BGML 1000/10

‘- Warp-free, solid tubular frame construction made of high-quality steel
in accordance with DIN 2448
– Primer and top coat in RAL 6010 (grass green) in accordance with DIN EN ISO 12944
– 3-piece trough-shaped idler roller station, top, approx. 30°
– 1-piece trough-shaped idler roller station, bottom, approx. 0°
– Idler rollers with precision deep-groove ball bearings, type 6204, in accordance with DIN 625, and permanently greased with double labyrinth seals to the outside
– In assemblies, consisting of drive and deflection stations
with intermediate sections corresponding to the overall length
– Sections with sturdy 2-hole flange connections and fixing materials
– Drive and deflection drums to DIN 2448, double-tapered
– End and tension head bearings with cast housing and precision deep-groove ball bearings to DIN 625, grease-filled with external seal and grease nipple
– Inner belt rubber plough scraper
– Standard outer belt rubber strip scraper, weight-loaded and self-adjusting ### without outer belt scraper system
– Smooth rubber belt type EP 400/3 – 4:2 NQ to DIN 22102, approx. 9 mm thick, endless, hot-vulcanised ### Rubber steep conveyor belt type EP 400/3 – 3:1.5 NQ to DIN 22102 with 15 mm V/Y profile, approx. 7 mm thick, endless, cold-vulcanised
– with feed hopper, approx. 1,200 mm long, approx. 230 mm high, galvanised
– with anti-entrapment guards for lower belt rollers and drive section, top, galvanised
– without emergency stop device (available on request at extra cost)
– without side guides (available on request at extra cost)
– without wear package (available on request at extra cost)
– without cabling, associated electrical work, installation or commissioning

Centre distance (AA) / belt width (GB): 10 m / 1,000 mm
Dimensions (L/W/H): approx. AA+800 / 1,300 / 650 mm (outer tube dimensions)
Support roller/shaft Ø: 89/20 mm
Pitch of roller station, top: approx. 1,000 mm, narrower in the feed area
Pitch of roller station, bottom: approx. 2,000 mm
Return drum Ø: 420 mm according to DIN 2448 with spindle clamping device, adjustable, clamping stroke approx. 500 mm
Drive drum Ø: approx. 420/436 mm according to DIN 2448, with rubber friction lining, knurled
Drive pin Ø: 60 mm with keyway according to DIN 6885
Longitudinal tubes Ø: 60 mm according to DIN 2448

Drive via:
Bevel gear motor
Voltage/frequency: 3-phase D/Y 230/400 or 400/690 volts at 50 Hz
without backstop or motor brake
Protection class: IP 54 or 55
Drive power: 7.5 kW
Output speed: approx. 57 rpm
Speed: v = approx. 1.3 m/s
Motor mounting: on the left in the direction of conveyance, pulling

Downloads:

Data sheet_BGM

BGM Operating Manual_2.0