BGML 1200/30

– Torsion-free, solid tubular frame construction made of high-quality steel in accordance with WDT_KEEP_0 2448
– Primer and top coat in RAL 6010 (grass green) according to DIN EN ISO 12944
– 3-piece moulded support roller station, top, approx. 30° – 1-piece moulded support roller station, bottom, approx. 0° – Support rollers with precision deep groove ball bearings type 6204 according to DIN 625 and permanent grease filling with double labyrinth seal to the outside
– In assemblies consisting of drive and deflection stations with intermediate pieces corresponding to the total length – Sections with stable 2-hole flange connections and fastening material – Drive and deflection drums according to DIN 2448, double conical turned
– Standing and clamping head bearings with cast housing and precision deep groove ball bearings according to DIN 625 and grease filling with external seal and grease nipple – Inner belt rubber scraper
– Standard outer belt rubber strip scraper, weight-loaded and self-adjusting ### without outer belt scraper system
– Smooth rubber belt type EP 400/3 – 4:2 NQ according to DIN 22102, approx. 9 mm thick, endless, hot vulcanised ### open ### Rubber steep conveyor belt type EP 400/3 – 3:1.5 NQ according to DIN 22102 with 15 mm V/Y profile, approx. 7 mm thick, endless, cold vulcanised ### open
– with feed hopper, approx. 1,400 mm long, approx. 302 mm high, galvanised – with anti-interference devices for lower belt rollers and for drive section, top, galvanised – without emergency stop device (available on request at extra cost) – without side guides (available on request at extra cost) – without chassis or supports (available on request at extra cost) – without walkways (available on request at extra cost) – without cabling, further electrical work, assembly or commissioning Centre distance (AA) / belt width (GB): 30 m / 1,200 mm
Construction dimensions (L/W/H): approx. AA+800 / 1,570 / 720 mm (outer dimensions of pipe) Support roller/axle Ø: 89/20 mm
Roll station pitch, top: approx. 1,000 mm, narrower pitch in the feed area, bottom: approx. 2,000 mm Deflection drum Ø: 420 mm according to DIN 2448 with spindle clamping device, adjustable, clamping range approx. 500 mm
Drive drum Ø: approx. 420/436 mm according to DIN 2448, with rubber friction lining, knurled Drive pin Ø: 60 mm with key according to DIN 6885
Longitudinal tubes Ø: 70 mm according to DIN 2448 Drive by: Bevel gear motor Voltage/frequency: 3-phase D/Y 230/400 or 400/690 volts at 50 Hz without backstop or motor brake Protection class: IP 54 or 55 Drive power: 7.5 kW Output speed: approx. 57 rpm
Speed: v = approx. 1.3 m/s Motor mounting: on the left in the direction of conveyance, pulling Downloads: Data sheet_BGM

Operating manual BGM_2.0