BERTRAM Conveyor belt type NBFSV 1400/15
hot-dip galvanised version (rotating and attached parts not galvanised)
Smooth rubber belt type EP 400/3 – 4:2 NQ to DIN 22102, approx. 9 mm thick, endless
Bevel gear motor, 7.5 kW, 73 rpm, approx. 1.3 m/s, left-hand drive, pulling
Delivery time: 7–8 weeks after receipt of order, subject to change.
Please complete the following information in full. If you have any questions, we would be happy to advise you personally on the telephone number provided.
– Low-profile assembly conveyor system made from U 200 longitudinal beams
– Hot-dip galvanised (rotating and attached parts not galvanised)
– with bolted connections and support feet
– In assemblies, consisting of drive and deflection stations
with intermediate sections corresponding to the total length
– Drive and deflection drums in accordance with DIN 2448, double-tapered
– Fixed and tension head bearings with cast housing and precision deep-groove ball bearings to DIN 625, permanently greased with external sealing and grease nipple
– Bolted roller stations in the upper and lower runs
– Triple-grooved support roller station, approx. 30°
– Support rollers with precision ball bearings type 6204 and permanent grease filling
– Smooth rubber belt type EP 400/3 – 4:2 NQ according to DIN 22102, approx. 9 mm thick, endless, hot-vulcanised ### Rubber steep conveyor belt type EP 400/3 – 3:1.5 NQ to DIN 22102 with 15 mm V/Y profile, approx. 7 mm thick, endless, cold-vulcanised
– Inner belt rubber strip scraper
– Standard outer belt rubber strip scraper, weight-loaded and self-adjusting ### without outer belt scraper system
– with anti-entrapment devices for lower belt rollers and for drive section, top, galvanised
– with feed hopper, 1.4 m long, galvanised
– without emergency stop device (available on request at extra cost)
– Without cabling, further electrical work or installation
Centre distance (AA) / Belt width (GB): 15 m / 1,400 mm
Construction length / width / height: approx. AA + 500 mm / 1,770 mm / 863 mm
(Dimensions: up to OK upper support roller)
Support roller / shaft Ø: 89/20 mm
Pitch of roller station: approx. 1,000 mm, narrower in the feed area
Deflection drum Ø: 320 mm, with spindle clamping device (approx. 300 mm clamping travel)
Drive drum Ø: 320 mm, rubber-coated
Drive pin Ø: 60 mm
Drive via:
Bevel gear motor
Voltage/frequency: 3-phase D/Y 230/400 or 400/690 volts at 50 Hz
Protection class: IP 54
Drive power: 7.5 kW
Output speed: approx. 73 rpm
Speed: v = approx. 1.3 m/s
Motor mounting: on the left in the direction of conveyance, pulling
Downloads:
Please register or log in to view prices or request a quote.
