BERTRAM Conveyor belt type NBFSV 1400/20 in hot-dip galvanised design (rotating and add-on parts not galvanised)
Smooth rubber belt type EP 400/3 – 4:2 NQ according to DIN 22102, approx. 9 mm thick, endless
Bevel gear motor, 7.5 kW, 73 rpm, approx. 1.3 m/s, in left-hand conveying direction, pulling Delivery time: 7-8 weeks after receipt of order, subject to change.
Please fill in the following information completely. If you have any questions, we will be happy to advise you personally at the telephone number provided.
– Low assembly conveyor belt system made of U 200 longitudinal beams – in hot-dip galvanised design (rotating and add-on parts not galvanised)
– With screw connections and support feet – In assemblies consisting of drive and deflection stations with intermediate pieces corresponding to the total length – Drive and deflection drums according to DIN 2448, double conical turned
– Standing and tensioning head bearings with cast housing and precision deep groove ball bearings according to DIN 625 and permanent grease filling with external seal and grease nipple – Bolted roller stations in upper and lower runs – Triple-grooved support roller station, approx. 30°
– Support rollers with precision ball bearings type 6204 and permanent grease filling – Smooth rubber belt type EP 400/3 – 4:2 NQ according to DIN 22102, approx. 9 mm thick, endless, hot vulcanised ### Rubber steep conveyor belt type EP 400/3 – 3:1.5 NQ according to DIN 22102 with 15 mm V/Y profile, approx. 7 mm thick, endless, cold vulcanised – Inner belt rubber strip scraper
– Standard outer belt rubber strip scraper, weight-loaded and self-adjusting ### Without outer belt scraper system – With anti-interference devices for lower belt rollers and for drive section, top, galvanised – With feed hopper, 1.4 m long, galvanised – Without emergency stop device (available on request at extra cost)
– Without cabling, further electrical work or installation Centre distance (AA) / belt width (GB): 20 m / 1,400 mm
Construction length/width/height: approx. AA + 500 mm / 1,770 mm / 863 mm (dimensions: up to OK upper support roller) Support roller/axle Ø: 89/20 mm
Roll station pitch: approx. 1,000 mm, narrower in the feed area Deflection drum Ø: 320 mm, with spindle clamping device (approx. 300 mm clamping range) Drive drum Ø: 320 mm, rubberised Drive pin Ø: 60 mm Drive via:
bevel gear motor Voltage/frequency: 3-phase D/Y 230/400 or 400/690 volts at 50 Hz Protection class: IP 54 Drive power: 7.5 kW Output speed: approx. 73 rpm
Speed: v = approx. 1.3 m/s Motor mounting: on the left in the direction of conveyance, pulling Downloads: Data sheet_NBFS_V2.0 Operating manual NBFS_2.0
Please register or log in to view prices or request a quote.
